Dating french clocks how i started a dating empire friend

Posted by / 09-Oct-2019 14:39

Dating french clocks

Another Lantern clock, C1675, with the "new" long pendulum and anchor escapement this clock had to be hung on the wall to run.Often known as "hoop and spike" clocks because of the iron hoop to hang the clock from, and the spikes at the bottom to dig in the wall and keep the clock steady.Very few Northern makers used this movement, it was essentially the same as the even earlier Lantern Clock movement.Northern makers had no tradition of making these clocks, so used the normal plated movement (vertical plates, horizontal pillars) from the start of their clockmaking.1700 to 1740 the size went to ten inches square, 1740 to 1770 the dial is likely to be eleven inches, and by 1770 the size went to twelve inches and stayed that size.There are exceptions to these sizes of course, but they are a good general guide when taken with other features.From around 1730 -1770 (all these figures are approximate) the brass dial clock was made all over England in ever-increasing numbers, and the dials became more ornate as time went on, especially on the eight-day clocks.

Now instantly recognisable as a longcase, or "grandfather" clock.This style lasted for two hundred years till around 1880, when huge imports of cheap mass-produced German and American clocks put an end to longcase manufacture for good.Only a few custom-built grandfather clocks were made after this date.A "bird-cage" movement (it has vertical pillars and the plates are horizontal top and bottom) is often taken to be a sign of an early clock.This is not guaranteed however, in Southern England the clockmakers continued to make this type of movement from the start right through to 1820.

dating french clocks-20dating french clocks-77dating french clocks-44

From now on the timekeeping of clocks improved by a huge amount using the longer pendulum and "anchor" escapement.

One thought on “dating french clocks”